Журнал аэронавтики и аэрокосмической техники
Открытый доступ

Абстрактный

Design and Analysis Aircraft Nose and Nose Landing Gear

Rajesh A and Abhay BT

Tri-cycle arrangement landing gear is extensively used as it is simple; convenient both structurally as well as aerodynamically. Though it is advantageous over other configuration is has its own draw backs. Factors like its weight drag, sudden application of load, acoustics, fatigue etc tend to slow down its performance and life. Among main landing gear and nose landing gear; the former carries about 85% of total weight of aircraft and latter carries around 12-15% of weight. The nose landing gear is also a source of noise and its effect is prominent when compared to main landing gear. In this project the executive jet aircraft are studied thoroughly and a nose landing gear similar to those of executive jets is modeled using CATIA. The same geometry is imported to ANSYS ICEM and flow on the body is analyzed for different angle of attack. Pressure variation, temperature, density and velocity distribution around the body is noted and then Coefficient for Lift and Drag are plotted against angle of attack for obtained results. It is also important to check the strength and stiffness of designed landing gear. Hence using ANSYS APDL and Explicit; Static structural and Impact test has been carried out for designed geometry. Stress distribution and deformation was noted for two distinct materials such as steel and aluminum alloy and primary results of acoustics has been compared with the available data.